EcoStretchRoll wrinkle removal for converting applications
I refer to the ESR (EcoStretchRoll) as the W.O.W. roller because it is designed to remove Wrinkles Out of Webs.
A different approach to wrinkle removal
The ESR was developed by the same designer who invented the Mink Brush Roller, with a design intended to address concerns raised by users of bristle rollers. Dirty bristles can leave marks on webs, may scratch coatings, or cause damage to thin or fragile substrates. Loose bristles can also fall off, ending up in your product.
Soft thermoplastic elastomer (TPE) elements gently but actively move material from the center outward, effectively removing wrinkles. Once a wrinkle is pressed into a web, it becomes a permanent crease. The ESR helps prevent this.

Versatility across materials and web widths
We have used the ESR with a variety of substrates, including films, paper, foils, nonwovens, and textiles.
This versatility makes it a good fit for custom converters that run many materials and make frequent changeovers throughout the day. Other technologies may require adjustments or may be less effective across different web widths. The roller’s flat face adds no tension to the web, reducing material damage or stretch.
Using the EcoStretchRoll
Application limits, maintenance and installation
Application considerations
Like all technologies, the ESR has limits. Its tension range of 0.05 to 4 PLI covers most applications, and materials running at higher tensions tend to be less prone to wrinkling. The ESR is well suited to pre-slit applications but, in most cases, is not a good fit for post-slit applications.
Wear and maintenance
The question of wear comes up often. With more than nine years of use in plants around the world and two years in the United States, we have seen very little wear. Damage from cuts or web wrap-ups has occurred, but the design allows for straightforward maintenance and repair when needed.
Simply remove the damaged rings, slide the remaining rings along the roller, add replacement rings at the end, and reinstall the end cap with a few screws. Grooves in the aluminum base and internal guides on the rings make replacement easy and prevent ring rotation and misalignment.
Straightforward installation
The dead-shaft design makes installation easy when replacing an idler or another roll. Clamp-style mounts also simplify installation in new applications. Position the mounts, level and tram them, and bolt them to the frame or use a pillow-block-style mount. Remove the two clamping screws, set the roller in place, and reinstall the clamp.
Customers return for more
We have had considerable success with this product. Many customers try one roller to see whether it performs as advertised, then return to purchase more. That is the testament I rely on: if the rollers did not work, we would not see so many returning users.
Our team has small samples to demonstrate how effective the roller is. Contact us for a demonstration of the technology and be WOWed.
Tim Roddy
VP of Business Development
Web Tech Assembly Solutions
1875 E. Main Street, Suite 7
Duncan, SC 29334
tim@webtechteam.com
864-494-9886
